Anyone's have any experience with this Ruger?

[CitizenBBN]

CBBN, can you tell exactly where the round entering the chamber is being held from feeding correctly? After thinking about it some, it sounds to me like the bolt face that butts up against the rear of the cartridge as the bolt face pushes it into the chamber may not be aligning correctly. If so, it's the bolt, not the round that is the issue.
What brand is the bolt? Is it mil-spec, or SAAMI standard? Is it a name brand bolt, or an aftermarket unit?

Then again, I haven't seen it myself, so I could be all wrong. But based on my experiences with this particular weapons platform, that is what I believe the problem could be.

Thanks, I appreciate the advice. I havent' worked on ARs much, so I'll take any suggestions I can get.

It's a commercially made piece, and a reputable one. I'll have to look it up and I'll check on a couple of things and post back on what I find.